• high viscosity
• high strength
• hard to disassemble

Gasketing of flanges, gearboxes and other motor  housings

Pretreatment of the surface
In general, WEICONLOCK does not require special pretreatment as slightly oily surfaces (e.g. on as received parts) will be tolerated. However, the best results will be achieved on cleaned, degreased parts (use WEICON Surface Cleaner). If required, the parts should be slightly roughened.

Processing
WEICONLOCK is ready for use and should be applied evenly direct
from the bottle/tube with the dispensing tip (avoid direct contact of
dispensing tip with metal). On press fitted parts and larger cylindrical
assemblies a thin and uniform layer should be applied on both
surfaces. In the case of threaded blind holes fill sufficient quantity in the
bore hole. On screws and bolts, apply WEICONLOCK around the
thread.

Do not pour back into the bottle any WEICONLOCK fluid which had
contact with metal; even smallest metal particles will cause the content
of the bottle to cure. In series construction, the use of manual or
automatic applicators is recommended.