Aluminum Coating for Heat Resistance Up To +600°C

Product Description

ASV®AL 600 is a high heat resistant paint type coating based on aluminum pigments and a special binder system. It air dries quickly on application and forms a long-lasting finish that is resistant to surface temperatures reaching as high as 600°C and is specifically designed for use on metal surfaces subjected to extreme heat. ASV® AL 600 does not contain any chlorinated solvents, CFCs, or ozone depleting chemicals.

Applications

For all exposed metal surfaces, especially where extreme heat resistance is required, such as chimneys, stoves, piping, engines, ovens, steam pipes, kilns, heaters, manifolds, mufflers, incinerators, space heaters. 

Benefits

 Brilliant finish aluminum coating.

 Fast air drying  Protects against rust & corrosion

 Non-corrosive and does not fade, crack or peel

 Useful on interior and exterior applications

Directions for Use

Clean and degrease the surface prior to application. Remove all rust and loose scales by wire brush. Shake can well for a couple of minutes till bearing noise from inside the can is audible. Repeat the same before every application. Spray light, even coats with sweeping action of the hand onto completely dry surface. Allow solvents to completely evaporate before re-application. Optimum desired film thickness is about 2-3 mils. Drying time to touch is about 10-15 minutes, to handle is about one hour and for complete cure is about 24 hours. Flush away paint products or product residues in the dip tube of the valve by cleaning it. Cleaning of the valve should be performed after spraying is finished, by inverting the can and pressing the actuator button in short bursts till only the propellant comes out. If required, to prevent clogging, remove the actuator button and clean the button orifice with a thin, fine wire.

Caution

Contains flammable solvents and propellant. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation.