Firm, Dry Waxy Film Type Long Term Corrosion Inhibitor 

Product Description

ASV® RNC 60 is a firm waxy film type corrosion inhibitor for providing long term indoor and outdoor surface protection for all metals and components for up to 2 years. It is highly resistant to humidity and salt spray and forms a protective shield against rust, moisture, heat and corrosive influences. ASV® RNC 60 is safe for use on all metals, rubbers, plastics and paint finishes and is ideal for use as a heavy-duty corrosion protective coating for parts in storage or during shipment. It does not contain any chlorinated solvents, CFCs or any ozone depleting substances. Meets requirements of Military Standards MIL-C-16173. Gr.4 

Applications

ASV® RNC 60 can be used for applications involving protection of metal surfaces in storage, service or shipment for providing long term, heavy-duty corrosion protection as: cranks, engine assemblies, bearings, gears, valves, spindles, chains & hoists, wire ropes, steel cables, dies & molds, lathes, mechanical instruments. 

Benefits

 Firm waxy film completely seals out moisture

 Prevents formation of rust & corrosion  Heavy duty corrosion inhibiting film assures complete rust protection

 Highly resistant to humidity & salt spray

 Provides long term corrosion protection for up to 2 years outdoors

 Removal of the film is very easy with any industrial solvent based degreaser 

Directions for Use - Bulk

Apply onto clean, dry and degreased surfaces by means of brush or by dipping components into the fluid. Ensure removal of rust, loose scales, dirt, dust and trapped moisture from surfaces before application. Mask areas not required to be coated. Apply uniformly a light film for maximum coverage. Two light films are better than a single thick film. For thicker films, recoat only after previous coat dries. Reuse as required. 

Directions for Use - Aerosol

Shake can well before use. Spray onto clean, dry and degreased surfaces. Ensure removal of rust, loose scales, dirt, dust and trapped moisture from surfaces before application. Mask areas not required to be coated. Spray uniformly a light film for maximum coverage. Two light films are better than a single thick film. For thicker films, recoat only after previous coat dries. Reuse as required. 

Caution

Contains flammable solvents. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation.