I. Product Description

Lectra Clean® is a chlorinated solvent-based degreaser that is extremely effective in most heavy duty applications. It dissolves grease, oil, tar, dirt, grime, corrosion, sludge and other stubborn substances to increase operating efficiency of electric motors and equipment. Lectra Clean® evaporates quickly, is non-conductive, non-corrosive, and non-staining. Lectra Clean® is non-flammable and non-ozone depleting. 

II. Applications :

Recommended for the effective removal of grease, oil, corrosion, sludge and other contaminants from electric equipment such as electric motors, armatures, relays, electric panels, or generators.

III. Features & Benefits :

• Non-flammable, no flash point

• Can be used on energized equipment – Minimizes downtime, spray on while in use

• Rapid and complete evaporation – Leaves no residue, no rinsing or wiping required

• Quickly penetrates into hard-to-reach areas

• Ideal for preparing surfaces for further treatment– Prior to anti-corrosive coating, painting, pre-assembly degreaser

• Ideal for cleaning water and contaminants from flood damaged equipment

• Chemically stable, inert

• Non-conductive

• Non-corrosive

• Contains no lubricants, silicones, oils

• May be harmful to some plastics

• NZFSA Approved C12

• USDA Authorized for use in Federally inspected Meat and Poultry Plants.

• NSN 4940-01-089 1084 Aerosol

IV. Directions for Use

• Test on small area before using. May be harmful to some plastics.

• Remove access plates to expose equipment interior.

• For heavy deposits, remove by scraping.

• Apply liberally by spraying and allowing to run off.

• Air dry or dry with soft wiper.

• If necessary, repeat application. 

Disposal

Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in conformance with local, state and federal regulations.

 Special Use Warnings

Aerosol Cans

Do not puncture, incinerate or store above 120

 F. Exposure to high temperatures may cause can to burst. Do not place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to observe this warning may result in serious injury from flash fire and/or electrical shock.

General

Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical assistance. Avoid continuous breathing of vapor and spray mist. Avoid contact with skin and eyes. If ventilation is not adequate, respiratory protection should be worn. For information regarding short term and long term exposure, review this product’s Material Safety Data Sheet.