Product Description

ASV® RC 60 red insulating varnish is a coating with exceptional insulating properties for electrical and electronic equipment to provide surface protection against oils, water, moisture, acids, alkalis and varying temperatures. Dry to touch in 10 minutes after application, and tack free within 45 minutes, this fast air drying, flexible coating has excellent adhesion to metal windings and coils with a temperature Class F (155°C) rating and high dielectric strength. ASV® RC 60 offers complete surface protection by sealing out water and moisture while possessing excellent penetrating and adhesive properties along with resistance to oils. 

Use ASV®RC 60 protective coating to insulate and seal:

 Motor Windings

 Terminals  Bus Bars

 Commutator Ends

 Stator Coils

 End Turns on Electrical Windings

 Printed Circuit Boards

 Rewound Motors

 Generators

 Transformers

 Phenolic / Porcelain Molded Parts

 Magnets

 Improving Megaohm and dielectric values of new as wellas rebuilt motors

 Highly suitable for insulating electrical windings that are exposed to extreme moisture and corrosive conditions as well as temperature and voltage fluctuations. 

Benefits

 Possesses high dielectric strength, surface and volume resistivity to provide effective insulation of electrical equipment

 Hard, durable & flexible protective film does not peel, crack or age and offers protective resistance to shocks, abrasion as well as aggressive chemical environments

 Fast air-drying, stable, single component coating with excellent resistance against oils, chemicals, ageing, moisture condensation, weathering effects

 Seals out moisture with a visible, highly glossy, smooth abrasion resistant protective coating  Highly heat resistant coating suitable for Class F insulation with greater allowance for thermal expansion and contraction

 Improves Megaohm and dielectric values  Very good adhesion on a variety of substrates

 Oil resistant to ASTM D 11 

Shake can well before use. Clean thoroughly and dry the surface to be coated before application of this coating. Mask area not to be sprayed. Spray from 12-15 inches away in light, even coats with a sweeping action of the hand. Allow solvents to evaporate completely before re-application. Additional coats for heavy film can be applied when first coat is dry. Coating becomes dry to touch in about 20-30 minutes. Clean the valve by inverting the can and spraying a few short bursts till only the clear propellant comes out. Clean the actuator button orifice by means of a thin, fine wire.  

Caution: Contains flammable solvents and propellant. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation.